S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-389
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
MODULE Messages
Error Message
MODULE-2-MOD_SOMEPORTS_FAILED: Module [dec] (serial: [chars])
reported failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in
device [dec] (error [hex])
Explanation
Module [decimal digit] reported a failure in the runtime diagnostic due to failure in
some of the ports.
Recommended Action
Collect information about the module by issuing the command 'show module
internal all module [decimal digit]'.
Error Message
MODULE-2-MOD_UNKNOWN: Module type [[dec]] in slot [dec] is not
supported
Explanation
The software card id of module [decimal digit] is not supported by the supervisor.
Recommended Action
Collect information about the module by issuing the commands 'show module
internal all module [decimal digit]'.
Error Message
MODULE-2-XBAR_DIAG_FAIL: Xbar [dec] (serial: [chars]) reported
failure [chars] due to [chars] in device [dec] (device error [hex])
Explanation
The xbar in slot [decimal digit] reported a failure in the runtime diagnostic. Module
manager is going to power cycle the module.
Recommended Action
Collect information about the module by issuing the command 'show module
internal all xbar [decimal digit]'.
Error Message
MODULE-2-XBAR_FAIL: Initialization of xbar [dec] (serial: [chars])
failed
Explanation
Xbar [decimal digit] reported a failure during the initialization phase and will be
powered down.
Recommended Action
Collect information about the module by issuing the commands 'show
module_internal all xbar <module number>'.
Error Message
MODULE-2-XBAR_SOMEPORTS_FAILED: Xbar [dec] (serial: [chars]) reported
failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec]
(error [hex])
Explanation
Xbar [decimal digit] reported a failure in the runtime diagnostic due to failure in some
of the ports.
Recommended Action
Collect information about the module by issuing the command 'show module
internal all xbar [decimal digit]'.
