S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-771
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message
URIB-3-PTDEL_ERROR Format: Could not delete %s/%d from the URIB pt,
error code %d
Explanation
A severe route table error was encountered. The system may run into more errors
because of this problem.
Recommended Action
Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
URIB-3-QADD_ERROR Format: Could not add %s to the %s queue
Explanation
A severe queue error was encountered. The system may run into more errors because
of this problem.
Recommended Action
Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
Error Message
URIB-3-RANGE_CHECK_ERR Format: Range check of %s failed from %s
(0x%08x)
Explanation
The value provided is outside of the acceptable range.
Parameters: Range, Provider of value, Value Provided ...
Recommended Action
Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message
URIB-3-RNH_LOOP_ERROR Format: Number of prefixes forming rnh loop
exceeds %d\n Flagging route %s/%d from client \%s\ with nh %s, rnh %s/%d\n as
causing rnh loop
Explanation
URIB detected a loop between routes installed in the RIB. The message shows which
client caused the loop.
Parameters: Max RNH Loop, Prefix, Prefix Length, Client, Next-hop, Prefix, Prefix Length ...
Recommended Action
Requires operator to intervene.
Error Message
URIB-3-RPM_LIB_ERROR Format: %s %d
Explanation
An RPM library function returned an error.
Parameters: Function, RPM Error Code ...
Recommended Action
No action is required.
