S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-770
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message
URIB-3-NO_L3VM_INFO_ERROR Format: no L3VM info for table id 0x%08x
from client \%s\ - unknown to L3VM
Explanation
A client tried to add some information to URIB and provided a Table-Id that is unknown
in the system. The client should be restarted.
Parameters: Table-Id Client name ...
Recommended Action
Use the 'restart' command to restart the feature and clear this problem.
Error Message
URIB-3-NOT_INIT_L3VM_ERROR Format: L3VM info for table id 0x%08x from
client \%s\ not available - URIB not initialised with L3VM
Explanation
A client tried to add some information to the URIB, before URIB has registered for the
table information. The client should be restarted.
Parameters: Table-Id, Client name ...
Recommended Action
Use the 'restart' command to restart the feature and clear this problem.
Error Message
URIB-3-OPEN_CLIENT_SHM_ERROR Format: Failed to open client shared
memory \%s\: %s
Explanation
The calling process failed with the shown error while trying to open the named URIB
shared memory region. The status of the memory is shown in 'show process memory shared'.
Parameters: Name of shared memory region ...
Recommended Action
Use the 'restart' command to restart the feature and clear this problem.
Error Message
URIB-3-PSS Format: Error returned from %s, errno: 0x%08x (%s) in %s()
Explanation
URIB called a PSS API which returned an error. The error reported should be examined
for the cause.
Parameters: Failed API, Error Code, Error Description, URIB Function ...
Recommended Action
Use 'reload' command to reload the system. Be aware that this problem affects
all VDCs on the system.
Error Message
URIB-3-PTADD_ERROR Format: Could not add %s/%d to the %s pt, error
code %d
Explanation
A severe route table error was encountered. The system may run into more errors
because of this problem.
Recommended Action
Use the 'system switchover' command to switch over to the standby supervisor.
If no standby is present, or the standby is not ready, use the 'reload' command to reload the system.
The state of the standby can be checked using the 'show system redundancy ha status' command.
