S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
2-587
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
SCSI-TARGET Messages
SCSI-TARGET Messages
This section contains the SCSI-TARGET messages.
SCSI-TARGET-2
Error Message
SCSI-TARGET-2-PROC_ADD_NPORT_FAIL: Failed to set local nport with
SCSI-target driver error: [hex]
Explanation
SCSI-target process add nport with its peer kernel driver [hex]. No SCSI discovery can
be performed.
Recommended Action
Collect more information using the command 'show scsi-target internal driver'.
Error Message
SCSI-TARGET-2-PROC_OPEN_VHBA_DEVICE_FAIL: Failed to communicate with
SCSI-target driver error: [hex]
Explanation
SCSI-target process failed to communicate with its peer kernel driver [hex]. No SCSI
discovery can be performed.
Recommended Action
Collect more information using the command 'show scsi-target internal driver'.
Error Message
SCSI-TARGET-2-PROC_SET_SCSI_INDEX_FAIL: Failed to set SCSI index
SCSI-target driver error: [hex]
Explanation
SCSI-target process failed to set SCSI index with its peer kernel driver [hex]. No SCSI
discovery can be performed.
Recommended Action
Collect more information using the command 'show scsi-target internal driver'.
Error Message
SCSI-TARGET-2-PROC_WWNM_GET_WWN_FAIL: Failed to get local controller
pwwn from WWN Manager error: [hex] response: [hex]
Explanation
SCSI-target process used wwnm_bwt_get_local_controller_wwn() API for the port
wwn and it failed due to error [hex], response code [hex]. No SCSI discovery can be performed.
Recommended Action
Collect more information using the commands 'show process cpu' and 'show
system internal sysmgr service all'. See WWN Manager system error codes for reason.
Error Message
SCSI-TARGET-2-PSS_INIT_FAIL: pss initialization failed due to error:
[hex]
Explanation
SCSI-target process pss initialization failure due to error [hex]. No SCSI discovery can
be performed.
Recommended Action
Collect more information by using the show flash command. See the pss
system error codes for the information about the failure.