Agilent Technologies E5070B, Руководство пользователя

Страница: 472 / 769

466 Chapter 13
Setting and Using the Control and Management Functions
System Recovery
Step 8. The message as shown below appears. Press of the keyboard. If you want to cancel the
create user backup image, press here.
You chose to create a backup image file of your system.
The system will perform a quick integrity check of the file
structure on the C: Drive. It will then copy the C: partition to
an image file and store it on the System Recovery partition.
Press C to Continue or E to Exit: _
Step 9. The message as shown below appears. Press of the keyboard to start the create user
backup image. If you want to cancel the create user backup image, press here.
CAUTION! Interrupting this process may leave the system in an
unstable state. Allow the software to complete the
backup and recovery process. This may take up to 20
minutes depending on the system configuration.
Press C to Continue or E to Exit: _
CAUTION Never turn off the power during the create user backup image because doing so may
cause serious damage to the E5070B/E5071B.
Step 10. The create user backup image will be complete in about 5 minutes. When the create user
backup image is complete, the message as shown below appears. Press
, , and
of the keyboard at the same time to restart.
Remove the disk and Press CLT+ALT+DEL to restart your
system.
NOTE If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.