Thermo Scientific 5030i SHARP, Instruction Manual

Page: 346 / 403

C-Link Protocol Commands
Calibration
B-38 Model 5030 i SHARP Instruction Manual Thermo Fisher Scientific
Send: set cal flow span 17.2
Receive: set cal flow span 17.2 ok
set cal vac pres span value
This command automatically sets the vacuum span based on the vacuum
pressure entered at the time of calibration. The following example
successfully sets the new
value for vacuum span based on the vacuum
pressure to 120.5 mmHg.
Send: set cal vac pres span 120.5
Receive: set cal vac pres span 120.5 ok
set cal vac flow offset
This command automatically triggers the filter change and sets the new
value for vacuum and flow offset. The following example successfully sets
the vacuum and flow offset.
Send: set cal vac flow offset
Receive: set cal vac flow offset ok
coef pm
This command reports PM coefficient. The following example reports that
the PM coefficient is 1.200.
Send: coef pm
Receive: coef pm 1.200
set coef pm value
This command sets the PM coefficient to user-defined values to value ,
where value is a floating-point representation of the coefficient. The
following example sets the PM coefficient to 1.200.
Send: set coef pm 1.200
Receive: set coef pm 1.200 ok
coef sharp
This command reports SHARP coefficient. The following example reports
that the SHARP coefficient is 1.05.
Send: coef sharp
Receive: coef sharp 1.050
set coef sharp value
This command sets the SHARP coefficient to user-defined values to value ,
where value is a floating-point representation of the coefficient. The
following example sets the SHARP coefficient to 1.04.
Send: set coef sharp 1.04
Receive: set coef sharp 1.04 ok