Installation
Setup
Thermo Fisher Scientific
Model 5030
i
SHARP Instruction Manual
2-15
ambient T/RH sensor assembly. Tighten this adapter against the
stainless steel tubing using the two setscrews.
9.
Sleeve the tripod over the tripod adapter to a proper height and tighten.
If using a tripod, using the adjustable legs of the tripod, plumb the inlet
tube assembly.
10.
Attach the white ambient T/RH sensor radiation shield assembly onto
a portion of the exposed tripod adapter.
11.
Attach and tighten the 5/8-inch to 3/8-inch reducing T-fitting to the
5/8-inch stainless steel tubing.
12.
Place the PM
10
or PM
2.5
inlet into the 5/8-inch stainless T-fitting.
13.
Feed one end of the black 25-foot T/RH cable trough he roof flange
assembly and connect to the bottom of the ambient T/RH assembly.
14.
Connect the other end of the T/RH cable to the back of the instrument
(RH Temp).
15.
Attach the heater power connector to HEATER 1.
16.
Using the available 3/8-inch green vacuum tubing, connect the intake
of the pump to the vacuum fitting at the rear panel of the 5030
i
.
17.
Plug the pump power chord into the AC PUMP receptacle at the rear
of the 5030
i
instrument.
Summary of Contents for 5030i SHARP
