Strata CIX 200, Programming Manual

Page: 267 / 508

Trunks
Strata CIX Programming Vol.1 12/09
6-13
T
runks
01 Auto Release The Automatic Release timing: Select Disable if the CO does not send the automatic
release signal on the Loop start line. If the CO does send the auto release signal,
also known as Calling Party Control, set the detect duration time to 95ms or 450ms
depending how long the CO opens the loop to disconnect the line.
Possible values:Disable, Detect 95ms or Detect 450ms (default)
02 Short Flash Select Short Flash Time
Possible values:0~15, where 1 = 100msec. (default = 5, which is .5 seconds)
0 = no flash, 1 = .1 sec., 2 = .2 sec. – 15=1.5 sec. 5 is the most
common duration of a hookflash signal
When a telephone initiates the short flash signal to the CO line (using the short Flash
feature button or access code #450). The duration of a short flash is determined by
this command. Normally this signal is used to hookflash a centrex line. The short
flash range is 0 to 1.5 seconds in increments of 0.1 seconds.
03 Long Flash Select Long Flash Time.
Possible values:0, 5, 10, 15, 20, 25 and 30, where 5 = .5 seconds. (default = 5)
When a telephone initiates the long flash signal to the CO line (using the Long Flash
feature button or access code #451). The duration of a long flash is determined by
this command. Normally this signal is used to disconnect the line. The long flash
range is 0 to 3 seconds in increments of 0.5 seconds. Possible values: 0=no flash,
5=.5 sec., 10=1sec. 15=1.5 sec., 20=2 sec., 25=2.5 sec., 30=3 sec.
04 Pause after Flash Pause time after flash. After a flash signal is sent to a CO line, this timer determines
when the line will start to send the dialed digits to the other end.
Possible values:0~5, 0 = immediately sent, and 1sec.delay to 5 sec.delay
(default = 1 second delay before sending digits)
05 Response Timer The response timer is for analog DID/TIE lines that have the “start method” set for
“Timing” in Prog 300-06. After a line is seized this timer determines when the line will
start to send the dialed digits to the other end.
Possible values:0=immediatly sent, and 50 msec.delay to 500 msec.delay
(default = 500 msec delay before sending digits)
06 Call Abandon Timer The interval after which the CIX stops sending ring tone to stations when an
incoming call is abandoned (caller hangs up before the call is answered).
Possible values: 6 Seconds or 8 Seconds (default)
F
IELD
D
ESCRIPTION