Strata CIX 200, Programming Manual

Page: 173 / 508

System
Dial Number Plan
Strata CIX Programming Vol.1 12/09
4-13
System
09 Dial Input Timer Permits dialed input for a telephone and trunk using DTMF.
Possible values:0~60 sec. (default = 20)
10 Delay 1 Ringing
Timer
Specifies the time to wait before applying ringing to the phones designated
to ring on Delay 1.
Possible values:1~60 sec. (default = 12)
11 Delay 2 Ringing
Timer
Selects the time to wait before applying ringing to the phones designated to
ring on Delay 2.
Possible values:1~60 sec. (default = 24)
12 Door Unlock Timer Select the length of time to send an electrical signal to a door for releasing
the lock.
Possible values:1~30 sec. (default = 6)
13 9+11 Judgment Timer The 9+11 inter-digital timer provides a timing value for the system to wait for
additional digits to be dialed looking for the 911 or 9+911 dialed codes for
treatment using the E911 procedures rather than normal dialing treatment.
Possible values:1~30 sec. (default = 5)
14 Emergency Call
Timer
Sets a time for advancing the call to the next station in a list of destinations
for the call.
Possible values:10~180 sec. (default = 30)
15 ABR Busy Detection
Time
The Destination Busy Detection timer sets the time to wait while looking for
a busy condition on an external call. If detected, it will trigger the initiation of
the Automatic Busy Redial cycle.
Possible values:1~30 sec. (default = 5)
16 Lost Call Timer The Lost Call timer sets the time that a failed transfer recall will ring on the
originating station prior to attempting to recall a secondary location.
Possible values:1~600 sec. (default = 180)
17 Lost Call Final Timer The Lost Call Final timer sets the time that a failed transfer recall will ring on
the secondary location before being automatically disconnected.
Possible values:1~600 sec. (default = 30)
18 DTMF Tone Sending
Time
The DTMF tone sending duration for dialing on CO lines.
Possible values:80msec (default) or 160msec
19 Auto Disconnect Time after which an unsupervised trunk will be automatically released.
Possible values:0~60 min. (default = 0)
20 Tie Line Delay Timer This timer inserts a pause before any dialed information is sent to a Tie line.
This pause allows the distant end time to prepare for the receipt of dialed
digits.
21 Answer timer before
disconnect
If an incoming DISA call routes over a Tie line and the call is not answered
by the distant end within a certain period of time the DISA caller will be cut
off. The time period before cut off is determined by this setting.
F
IELD
D
ESCRIPTION