Strata CIX 200, Programming Manual

Page: 429 / 508

Maintenance
Event Trace Control
Strata CIX Programming Vol.1 12/09
11-3
Ma
in
te
n
a
nc
e
903 Start/Stop Trace
904 ISDN Trace Location
ISDN protocol event trace collection conditions are established using this program.
Note This trace can be performed on BSU and PTU cards only.
905 All ISDN Lines Trace Level Selection
F
IELD
D
ESCRIPTION
Start/Stop Trace Click in the appropriate button to start or stop Message Trace. Start Trace
indicates that the system’s trace data collection process has begun. Stop
indicates the trace data collection process is terminated
Before removing the SmartMedia card run Program 908. See “908 Secure
Digital and SmartMedia” on page 10-5 .
Possible values:Start Trace or Stop Trace (default)
Current Function Displays the last command sent to the CIX.
Completion Displays the progress of the current function.
Size [x16 Bytes] Set the trace data size. Toshiba recommends leaving this parameter at the
default setting which provides approximately 15 minutes of trace data.
Possible values:1~256 bytes with 1 unit = 16 bytes (default = 2)
Category Select Trace data type to be stored.
Possible values:Call Processing, Maintenance, and Call Processing and
Maintenance (default)
F
IELD
D
ESCRIPTION
Cabinet/Slot/Circuit Enter the Equipment Location to be traced (xxyyzz).
Possible values:xx = Cabinet 01~11; yy = Slot 01~10; zz = Circuit 01~04
Trace Kind Select the trace collection level.
Possible values:LLCI Trace, Layer 3, Layer 2 & 3, State Transitions, Errors,
Layer 2 States.
Trace Level Select the extent to which the trace collects information.
Possible values:No Trace (default), Brief or Extensive
F
IELD
D
ESCRIPTION
Trace Level For All
ISDN Lines Select whether to trace all ISDN PRI and BRI trunks.
Possible values:Set Extensive (default) or Set No Trace