Strata CIX 200, Programming Manual

Page: 462 / 508

Data Backup and Restore
Local Update
14-10
Strata CIX Programming Vol.1 12/09
3. Remove the formatted SmartMedia card from the CIX and install the SmartMedia card into a PC
SmartMedia reader/writer.
4. Copy the new Strata CIX software file named “nhs.prg” into SmartMedia card PROGRAM folder.
5. Create a SmartMedia Card Volume label “PRGUPDATE” on CIX Update SmartMedia card as shown:
• Select and right mouse click the appropriate SmartMedia drive, for example, drive E or G in some
computers.
• Click Properties.
• Under General tab, in the Label field enter label name (in this case PRGUPDATE).
6. Pull out the SmartMedia card and physically label it “CIX670, MXnnn, “CIX1200, MXnnn”” or whatever
software version you are updating to.
Note After completing Steps 1 and 2 above you should have two SmartMedia cards:
•
One card containing the CIX backed up database file: PROGDATA\default.dat
•
One card having the volume label “PRGUPDATE” and containing the CIX software Update file:
PROGRAM\nhs.prg
Step 3: Update CIX670 or CIX1200 Software
1. Insert the SmartMedia card containing PROGRAM\nhs.prg file into the CIX processor SmartMedia
socket.
2. From the programming telephone enter Program 911, and press Hold . Press FB01 and dial 1
(UPDATE) and then press Hold once. Pressing Hold twice will cause the Update to fail. This will not
interrupt the CIX system operation.
• If FB07-LED is flashing green it indicates that the Update process is in progress.
• If FB07-LED is flashing red it indicates an error. This could be caused by a corrupt or incorrect
nhs.prg file or a defective SmartMedia card. Make sure it is a CIX670 or CIX1200 nhs.prg file and
not a CIX100 file.
• You can now check the Update progress using FB02 (Total) and FB03 (Copied) to view data block
status. Periodically switch between FB02 and FB03 to view the data blocks.
• When FB07-LED is solid green with periodic short blinks, it indicates the first part of Update
completed successfully (2 to 10 minutes).
3. After FB07 is on solid green with a periodic wink, press Hold, while in Program 911. Press FB05 and
dial 2 (TRIAL) and then press Hold . This will change the status of the Standby Flash Memory to trial.
4. Pull out the SmartMedia card labeled PRGUPDATE (which includes PROGRAM/nhs.prg file).
5. Insert the SmartMedia CARD labeled “Strata CIX Backup data” into processor/ SmartMedia socket.
The SmartMedia LED on the processor begins to blink.
The “Strata CIX Backup data” SmartMedia card is the card you previously made that includes the Strata
CIX programmed data in the default.dat file under the PROGDATA folder. If this is not done before
starting Clear-reboot, all programmed data will be lost.
The next operation will take the system out of service for 10 minute to an hour depending on the size of
the CIX database.
6. From the programming telephone enter Program 911 and press Hold; press FB01 and dial 3
(CLRREBOOT) and then press Hold . This will Clear-reboot the system to switch the new software
version from standby to active and restore Backup data.