Chapter 8: Encryption Key Management
Setting up EKM on the Scalar i6000
Quantum Scalar i6000 User’s Guide
303
3
Fill in the rest of the fields as described in the sections below for
each server type:
on page 305 of this
document.
For primary and secondary servers, you can enter the following:
• IPv4 address
• IPv6 address — if IPv6 is configured
• DNS name — if DNS is configured on the LMC (
Setup >
Network Configuration > DNS Configuration
)
Q-EKM
a Enable SSL -
Select the check box if SSL communications should
be enabled between the library and encryption server(s).
b Primary EKM Server
- Type the IP address or DNS name of the
primary Q-EKM server.
c Primary port number
- If SSL is enabled, the default port
number is 443. If SSL is not enabled, the default port number is
3801. You can change the port number on the library, but, if
you do, you must also change the port number on the key
server to match or Q-EKM will not work properly. See the
Quantum Encryption Key Manager User’s Guide
for information
on setting the port number on the Q-EKM key server.
d Secondary EKM Server
- Type the IP address or DNS name of
the optional secondary Q-EKM server.
Note:
If you do not plan to use a secondary server, you may
type a zero IP address, 0.0.0.0, into the Secondary EKM
Server text box, or you may leave this text box blank.
e Secondary port number
- If SSL is enabled, the default port
number is 443. If SSL is not enabled, the default port number is
3801.
Note:
If you are using a secondary key server, then the port
numbers for both the primary and secondary key
servers must be set to the same value. If they are not,
synchronization and failover will not occur.
f Key Class
- This field is not applicable for Q-EKM.
Summary of Contents for Scalar i6000
