MAINTENANCE AND SERVICING
Engine Speed
The maximum and idle engine speeds are factory set.
Refer to
2.2 Specifications, page 31
for detailed information. If speci
fi
ed speeds cannot be maintained, see your
MacDon Dealer.
Refer to
Engine Intermediate Speed Control (ISC), page 163
for information about engine speed.
Throttle Adjustment
The engine speed is controlled with the throttle lever that is connected to an electronic sensor inside the console.
The throttle lever in the cab should move the throttle sensor the full range between slow speed stop and full rpm
stop without contacting the console at either position.
If the throttle lever is contacting the console and interferes with speci
fi
ed engine speeds, the sensor position may
need adjustment. See your MacDon Dealer.
5.5.8
Electrical System
Preventing Electrical System Damage
To prevent electrical system damage, take the following
precautions:
• Carefully
observe
polarity
when
attaching
booster battery.
• Do
NOT
short across battery or alternator terminals,
or allow battery positive (+) cable or alternator wire to
become grounded.
• Be sure alternator connections are correct before cables
are connected to battery.
• When welding on any part of the machine, disconnect
battery cables and alternator wire. Refer to
1.8 Welding
Precaution, page 9
.
• Always disconnect battery ground cable when working
with the alternator or regulator.
• Never attempt to polarize alternator or regulator.
• If wires are disconnected from the alternator, use the
illustration to ensure proper connections.
• Never ground the alternator
fi
eld terminal or
fi
eld.
• Never connect or disconnect alternator or regulator
wires with battery connected or alternator operating.
• Always disconnect cables from the battery when using
a charger to charge battery in windrower.
• Ensure all cables are securely connected before
operating engine.
Figure 5.117: Alternator
A - Negative Terminal
B - Positive Terminal
147649
368
Revision A
Summary of Contents for M155
