MacDon M155, Operator'S Manual

Page: 133 / 510

OPERATOR’S STATION
3.19.9 Activating Cab Display Lock Outs
You can lock some of the header functions controlled by the cab display module (CDM) to prevent accidental
changes to header settings. You can use this feature to keep header settings constant when several different
operators use the windrower.
NOTE:
FUNCTION LOCKED fl ashes on CDM when locked header function switch is pressed.
Activating Knife Speed Control Lock Out
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 213
.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.131: M155 CDM Programming Buttons
4. Press SELECT (B) until SET CONTROL LOCKS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (A) arrow to select YES. Press SELECT (B).
Figure 3.132: M155 Control Locks
147649
117
Revision A