![background image](http://html.mh-extra.com/html/macdon/m155/m155_operators-manual_685734158.webp)
OPERATOR’S STATION
7. Press SELECT (D) until ACTIVATE REEL F/A is
displayed on the upper line.
• FORE/AFT is displayed on the lower line.
8. Press and hold left (B) arrow to move reel
forward
.
Press and hold right (C) arrow to move reel
backward
.
Verify reel fore-aft is functioning properly.
9. Press
PROGRAM
(A)
to
exit
Programming
Mode or press SELECT (D) to proceed to next
ACTIVATE FUNCTION.
Figure 3.187: M155 Reel Fore-Aft
Activating the Hydraulic Purge Using the Cab Display Module (CDM)
The hydraulic purge removes air from the hydraulic pump system after it has been repaired or changed.
NOTE:
Engine
MUST
be running to perform this procedure.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
Figure 3.188: M155 CDM Programming Buttons
147649
142
Revision A
Summary of Contents for M155
