OPERATOR’S STATION
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (D) until ACTIVATE HEADER HT is
displayed on the upper line.
• DOWN/UP is displayed on the lower line.
8. Press and hold left (B) arrow to lower header or, press
and hold right (C) arrow to raise header. Verify header
is functioning properly.
9. Press
PROGRAM
(A)
to
exit
Programming
Mode or press SELECT (D) to proceed to next
ACTIVATE FUNCTION.
Figure 3.175: M155 Header Height
Testing the Reel Up/Down Activate Function Using the Cab Display Module (CDM)
NOTE:
• This procedure is for draper headers only.
• The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
4.5 Attaching and Detaching Headers, page 213
.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode. Press
SELECT (C).
• WINDROWER SETUP? is displayed on the
upper line.
Figure 3.176: M155 CDM Programming Buttons
147649
137
Revision A
Summary of Contents for M155
