MacDon M155, Operator'S Manual

Page: 123 / 510

OPERATOR’S STATION
4. Press SELECT (D) until OVERLOAD PRESSURE? is
displayed on the upper line.
• The current overload pressure is displayed on
lower line.
NOTE:
Pressure range is 2500–5000 psi (17,237–34,474
kPa).
5. Press left (B) or right (C) arrows to set hydraulic
overload pressure. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
Figure 3.108: M155 Hydraulic
Overload Pressure
Setting the Header Index Mode
Header Index feature is not applicable to rotary headers.
For more information on the Header Index feature, refer to
4.6.6 Reel Speed, page 282
and
4.6.7 Draper Speed,
page 286
.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 213
.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.109: M155 CDM Programming Buttons
147649
107
Revision A