OPERATION
10. Remove cotter pin on clevis pin (B) and remove pin to
disconnect from header. Reinstall clevis pin in header.
11. Tighten nut against barrel (A). A slight tap with a
hammer is suf
fi
cient.
Figure 4.274: Mechanical Center-Link
12. Disconnect
header
drive
hydraulics
(A)
and
electrical harness (B). Refer to the R-Series Header
Operator’s Manual.
13. Start engine and slowly back windrower away
from header.
Figure 4.275: Header Drive Hydraulics
14. Stops engine and remove the key.
15. Reinstall the clevis pin (A) through each boot (C) and
secure with hairpin (B). Do this to both sides.
Figure 4.276: Header Boots
147649
278
Revision A
Summary of Contents for M155
