MacDon M155, Operator'S Manual

Page: 94 / 510

OPERATOR’S STATION
Display (Lower or Upper Line) Description
##.# ACRES/HOUR
##.# HECTARES/HOUR (If Metric)
Actual cutting rate in acres (hectares)/hour.
###.# SUB ACRES
###.# SUB HECTARES (If Metric) Area cut since last reset. To reset, display SUB ACRES
on lower line, and hold down program switch until display
resets (5–7 seconds).
###### TOTAL ACRES
###### TOTAL HECT (If Metric)
Total area cut by machine.
##.## REEL RPM
##.## REEL SENSOR Reel rotational speed.
Sensor Disabled. RPM and SENSOR alternate at 1 second
intervals.
##.# AUGER SPEED Auger rotational speed (4.7–9.9).
#### KNIFE SPEED
#### KNIFE SENSOR Knife speed in strokes per minute.
Sensor Disabled. SPEED and SENSOR alternate at
1 second intervals.
##.# HEADER HEIGHT
##.# HEADER SENSOR Distance setting (00.0–10.0) between cutterbar and ground.
Sensor Disabled. HEIGHT and SENSOR alternate at
1 second intervals.
##.# HEADER ANGLE
##.# HEADER SENSOR Angle setting (00.0–10.0) header relative to ground.
Sensor Disabled. ANGLE and SENSOR alternate at
1 second intervals.
##.# L FLOAT R ##.#
FLOAT SENS DISABLED Left and right fl oat setting (0.0–10.0).
Sensor Disabled.
LOAD| ■■■■ | | ####
Bar graph representing hydraulic operating pressure.
Full scale is preprogrammed overload pressure
(2500–5000 psi). If sensor disabled, LOAD does not
display
5 .
### °C or F HYD OIL TEMP
### °C or F HYD TEMP
Hydraulic oil temperature.
Sensor Disabled. TEMP and SENSOR alternate at
1 second intervals.
##.# VOLTS Engine electrical system operating voltage.
SCROLL
SUB-MENU (Lower Line Only)
#### KNIFE SPEED
##.# HEADER HEIGHT
LOAD|
■■■■ | ■■■■ | ####
Displays sub-menu after 2–3 seconds. Press SELECT to
cancel. Scroll through sub-menu display with CDM switch.
5. The LOAD sensor to monitor knife/conditioner circuit pressure is optional. To monitor reel/auger circuit pressure,
relocate sensor as per Form MD #169031, which is available through your Dealer.
147649
78
Revision A