MacDon M155, Operator'S Manual

Page: 151 / 510

OPERATOR’S STATION
5. Press SELECT (B) until FORCE HEADER TYPE? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (A) arrow to select YES. Press SELECT (B).
• SELECT HEADER TYPE is displayed on the
upper line.
• DISK HEADER is displayed on the lower line.
Figure 3.170: M155 Header Type
7. Press left (A) or right (B) arrow to cycle through list of
header types.
8. When desired header type is displayed press
SELECT (C).
• EXIT FORCE HEADER? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
9. Press right arrow (B) to select YES. Press SELECT (C).
Proceed to next DIAGNOSTIC MODE or press
PROGRAM to exit programming mode.
Figure 3.171: M155 Header Type
3.19.12 Troubleshooting Header Problems
You can test individual parts of the header as part of a troubleshooting routine.
Testing the Header Up/Down Activate Function Using the Cab Display Module (CDM)
NOTE:
• The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 213
.
• The engine
MUST
be running to perform this procedure.
147649
135
Revision A