OPERATION
4.4.4
Header Drive
All header controls are conveniently located on the operator’s console and on the ground speed lever (GSL) handle.
NOTE:
Some controls are optional equipment and may not be present in your unit. Some controls may be installed, but
will be nonfunctional for certain headers.
Engaging and Disengaging the Header
IMPORTANT:
Always move throttle lever back to idle before engaging header drive. Do
NOT
engage header with engine
at full rpm.
CAUTION
Check to be sure all bystanders have cleared the area.
1.
To Engage Header:
a. Move throttle (A) to adjust engine speed to idle.
b. Push the center down and pull up the HEADER
DRIVE switch (B) to engage header drive. A slight
delay between switch ON and operating speed
is normal.
2.
To Disengage Header:
a. Push HEADER DRIVE switch (B) down to
disengage header drive.
Figure 4.90: Operator Console
147649
202
Revision A
Summary of Contents for M155
