MacDon M155, Operator'S Manual

Page: 224 / 510

OPERATION
4. Adjust the header angle with the HEADER TILT UP (E) or HEADER TILT DOWN (F) switches on the GSL. The
CDM displays between
00.0 and 10.0
. This step is not required when height only has been preselected.
5. Press the RETURN TO CUT switch (A) on the CDM. The indicator light will illuminate and the settings are now
programmed into the windrower control module (WCM).
Using the Return to Cut Feature
Figure 4.99: Operator Console
A - Return to Cut B - Header Up C - Header Down
D - Display E - Header Tilt Up F - Header Tilt Down
Use the RETURN TO CUT feature as follows:
IMPORTANT:
Ensure the header is engaged and the RETURN TO CUT switch (A) is illuminated.
NOTE:
The header can be raised or lowered by
pressing and holding
the HEADER UP (B) or HEADER DOWN (C)
switches on the ground speed lever (GSL).
1. If header is above the preset cutting height,
momentarily press
HEADER DOWN switch (C) and the header
will return to preset height.
2. If the header is below the preset height,
press and hold
the HEADER UP (B) switch to raise the header. Release
switch to stop header. Alarm will sound when header rises past the preset height.
3. If the header angle changes, double-click (two clicks within 0.5 seconds) the HEADER TILT UP (E) or HEADER
TILT DOWN switch (F) and the header will return to the preset angle.
147649
208
Revision A