MacDon M155, Operator'S Manual

Page: 129 / 510

OPERATOR’S STATION
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
Figure 3.121: M155 CDM Programming Buttons
Shown – M205 Similar
4. Press SELECT (C) until HAY CONDITIONER? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (B) arrow to select YES. Press SELECT (C).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (C) to proceed to next WINDROWER
SETUP action.
Figure 3.122: M155 Hay Conditioner Shown –
M205 Similar
Displaying Reel Speed
NOTE:
• This procedure is for draper and auger headers. It does not apply to rotary disc headers.
• The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 213
.
147649
113
Revision A