![background image](http://html.mh-extra.com/html/macdon/m155/m155_operators-manual_685734269.webp)
OPERATION
13. Disconnect
header
drive
hydraulics
(A)
and
electrical harness (B). Refer to the auger header
operator’s manual.
14. Back windrower slowly away from header.
Figure 4.208: Header Drive Hydraulics
15. Reinstall clevis pin (B) into header boot (C) and secure
with hairpin (A). Repeat for opposite side.
Figure 4.209: Header Boots
Detaching an A-Series Header: Mechanical Center-Link
WARNING
To avoid bodily injury or death from unexpected
startup of machine, always stop engine, and remove
key before making adjustments to machine.
1. Start engine and press header up button (A) on ground
speed lever (GSL) to raise header to maximum height.
2. If one end of the header does
NOT
raise fully follow
these steps to rephase the cylinders:
a. Press and hold the header up (A) switch until both
cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds.
Cylinders are phased.
3. Stop engine and remove key.
Figure 4.210: GSL
147649
253
Revision A
Summary of Contents for M155
