MacDon M155, Operator'S Manual

Page: 116 / 510

OPERATOR’S STATION
Calibrating the Header Float Sensors
NOTE:
• The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
4.5 Attaching and
Detaching Headers, page 213
.
• The Operator can use the left or right FLOAT buttons on the cab display module (CDM) to perform this procedure.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
3. Press SELECT (C) until CALIBRATE SENSORS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
Figure 3.93: M155 CDM Programming Buttons
4. Press right (B) arrow to select Yes. Press SELECT (C).
• TO CALIBRATE SELECT is displayed in upper line.
5. Press left (A) or right (B) arrow until HEADER FLOAT
is displayed on the lower line. Press SELECT (C).
• CALIBRATING FLOAT is displayed on the
upper line.
• PRESS FLOAT + TO START is displayed on the
lower line.
CAUTION
Check to be sure all bystanders have cleared the area.
Figure 3.94: M155 Header Float
147649
100
Revision A