MAINTENANCE AND SERVICING
IMPORTANT:
Clean the area around the plastic cap to ensure
nothing falls into gearbox oil reservoir.
5. Clean the area around the plastic cap on access
hole (A). Remove the cap.
6. Insert the barring tool (B) into the
fl
ywheel housing until
it engages the ring gear.
7. Attach a 1/2 in. square drive ratchet or breaker bar
and turn.
8. Remove barring tool (B) and clean oil from around
access hole.
9. Clean plastic cap and reinstall in access hole (A) with
silicone sealant.
IMPORTANT:
BATTERY IS NEGATIVE GROUNDED. Always
connect starter cable to the positive (+) terminal
of battery and battery ground cable to negative
(-) terminal of battery. Reversed polarity in
battery or alternator may result in permanent
damage to electrical system.
Figure 5.51: Access Hole Location for
Barring Tool
10. Attach negative (black) cables (B) to negative posts
on batteries, and tighten clamps.
Then attach
positive (red) cables (A) to positive post on batteries
and tighten clamps.
11. Position plastic covers onto clamps.
12. Close the hood, refer to
5.2.2 Closing Hood (Lower
Position), page 307
.
13. Close platform, refer to
5.3.2 Closing Platforms
(Standard Position), page 310
.
Figure 5.52: Battery Terminal Location
147649
334
Revision A
Summary of Contents for M155
