OPERATION
Driving Forward in Engine-Forward Mode
In the engine-forward mode, the Operator’s station is facing
toward the engine. If necessary, swivel operator’s station
to engine-forward position as follows:
Figure 4.20: Engine-Forward – Seat Faces
Engine
1. Place ground speed lever (GSL) (A) in N-DETENT and
lock steering wheel. Engine can be running.
IMPORTANT:
If GSL is
NOT
in N-DETENT, damage to the GSL
cable may result when swivelling operator’s station.
2. Pull up on knob (B) and hold to release latch (C) at
base of steering column.
3. Turn steering wheel clockwise to pivot operator’s
station counterclockwise 180° until pin engages latch
to secure operator’s station in new position.
4. Start engine if not running.
Figure 4.21: Engine-Forward – Seat Faces
Engine
5. Set ground speed range switch (A) to
H
for road speed
(0–23 mph [37 km/h]). Cab display module (CDM)
will display ROAD GEAR at (F) and an alarm will
brie
fl
y sound.
6. Slowly push throttle (B) to full forward (operating
speed). CDM should display 2320–2350 rpm at (C).
CAUTION
Check to be sure all bystanders have cleared the area.
7. Slowly move the GSL (E) forward to desired speed
which will be displayed at (D).
Figure 4.22: Operator Console
147649
170
Revision A
Summary of Contents for M155
