OPERATION
NOTE:
This procedure can also be used to change the draper speed “on the go”.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Engage header.
2. Set HEADER INDEX switch (B) to
OFF.
3. Press DISPLAY SELECTOR button (E) to show
##.# DRAPER SPEED
on the cab display module (CDM) (A).
Displayed value (##.#) = draper speed (mph or km/h
23
).
4. Press FAST (C) or SLOW (D) on the CDM until desired draper speed is displayed at (A).
4.6.8
Knife Speed
The ideal cutting speed of the knife should achieve a clean cut. Crop types and conditions usually in
fl
uence
the knife and forward speeds.
Table 4.2 Knife Speed Table
Header Description
Knife Speed
Minimum
Maximum
Type
Size (ft)
rpm
24
spm
25
rpm
24
spm
25
15
750
1500
950
1900
20 and 25
700
1400
850
1700
30
800
1600
Draper with
double knife
35
700
1400
20 and 25
750
1500
30
600
1200
Draper with
single knife
35
550
1100
700
1400
When the header is
fi
rst attached to the windrower, the windrower control module (WCM) receives a code from the
header that determines the knife speed range and the minimum speed.
The desired speed can be programmed on the cab display module (CDM) and stored in the WCM memory so the
knife will operate at the original set-point after the header is detached and reattached to the windrower.
If no header code is detected, the CDM displays NO HEADER and the knife speed reverts to the Operator’s selection
from a range of 800–1000 strokes per minute.
Refer to the header operator’s manual for the suggested knife speed for a variety of crops and conditions.
NOTE:
The knife speed cannot be programmed outside the range speci
fi
ed for each header.
23. Depending on CDM programming.
24. Revolutions per minute is the speed of knife drive box pulley
25. Strokes per minute of knife (rpm x 2)
147649
289
Revision A
Summary of Contents for M155
