MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 73 / 354

214685
61
Revision A
Chapter 5: Attaching Header to Combine
The procedures for attaching the header to a combine vary depending on the combine model. Refer to the following
table for the appropriate procedure:
Table 5.1 Combine Model Header Attachment Procedures
Combine Refer to
AGCO Gleaner R and S Series;
Challenger 660, 670, 680B, 540C, and 560C;
Massey 9690, 9790, 9895, 9520, 9540, and 9560
5.1 AGCO (Challenger, Gleaner, and Massey
Ferguson) Combines, page 61
Case IH 7010, 8010, 7120, 8120, 9120, 5088, 6088, 7088,
5130, 6130, 7130, 7230, 8230, and 9230
5.2 Case IH Combines, page 69
CLAAS 500, 600, and 700 (R Series) 5.4 CLAAS Combines, page 87
John Deere 60, 70, S, and T Series 5.3 John Deere Combines, page 75
New Holland CR and CX 5.5 New Holland Combines, page 92
IMPORTANT:
Ensure applicable functions (automatic header height control [AHHC], Draper Header Option, Hydraulic
Center-Link Option, Hydraulic Reel Drive, etc.) are enabled on the combine and in the combine computer. Failure
to do so may result in improper header operation.
5.1 AGCO (Challenger, Gleaner, and Massey Ferguson)
Combines
5.1.1 Installing Reel Fore-Aft / Header Tilt Selector Switch and Harness
Figure 5.1: Converted Gleaner R72 Shown
Gleaner combines prior to model year 2014 are not
equipped to accommodate hydraulic reel fore-aft and
header tilt options. The following additional items are
required and not supplied by MacDon:
•
Valve (A) (AGCO #71389745)
•
Hoses
•
Electrical components
•
Couplers
NOTE:
Model year 2014 and later Gleaner combines will have the
above parts factory-installed.
To enable the reel fore-aft and header tilt options, install the
switch and harness as follows:
IMPORTANT:
To prevent possible damage to electronic components, disconnect the positive cable from the combine battery
before connecting harness to combine connectors.