MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 32 / 354

214685
20
Revision A
Figure 3.8: Reel Arm Braces
9. Lift reel to gain access to the center lift cylinder.
10. Remove shipping wire and banding from center reel lift
cylinder. Remove socket head bolt and nut from
cylinder rod.
11. Lift reel so that hole in center lift cylinder rod lines up
with mounting hole in reel arm.
12. Attach rod end of cylinder to reel arm with socket head
bolt and nut (A). Access hardware through holes in reel
arm braces (C).
13. Torque bolt and nut (A) to 54
–
61 Nm (40
–
45 lbf·ft).
14. Remove pin at barrel end of cylinder.
15. Adjust reel height so pin (B) can be installed at barrel
end of cylinder and mounting structure.
Figure 3.9: Outboard Reel Arm
16. Reposition the sling (A) around the reel tube near the
opposite outboard reel arm.
17. Remove shipping wire and banding from the reel lift
cylinder.
ASSEMBLING HEADER AND FLOAT MODULE