MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 311 / 354

214685
299
Revision A
Figure 7.321: New Holland Combine Display
1. Engage threshing and feeder house.
2. Select HEIGHT SENSITIVITY on the combine
display screen.
3. Use the + or
–
buttons to change the setting to 200.
4. Press ENTER to save the new setting.
NOTE:
The sensitivity can be changed from 10
–
250 in steps
of 10. It is factory-set to 100.
Setting Preset Cutting Height (New Holland CR/CX Series)
To set the preset cutting height, follow these steps:
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to 7.1.16 New Holland Combines (CR
Series
—
Model Year 2015 and Later), page 300 .
Figure 7.322: Float Indicator Box
NOTE:
Indicator (A) should be at position 0 (B) with the header
(152 mm [6 in.]) off the ground. If not, the float sensor output
voltage should be checked. Refer to Step
4, page 159 .
When the header is on the ground, the indicator should be
at position 1 (C) for low ground pressure, and at
position 4 (D) for high ground pressure. Crop and soil
conditions determine the amount of float to use. The ideal
setting is as light as possible without header bouncing or
missing crop. Operating with heavy settings prematurely
wears the cutterbar wearplates.
SETTING UP AUTO HEADER HEIGHT CONTROL