214685
278
Revision A
Figure 7.275: John Deere Combine Display
8.
Press and hold REEL RAISE switch until reel is fully
raised. Continue holding REEL RAISE switch until
prompted by the display.
Figure 7.276: John Deere Combine Display
9.
When all steps have been completed, CALIBRATION
COMPLETE message is displayed on the screen. Exit
the CALIBRATION menu by pressing the ENTER
icon (A).
NOTE:
If an error code appears during calibration, the sensor is
out of voltage range and will require adjustment. Refer
to
Checking Reel Height Sensor Voltages (John Deere
.
7.1.14
John Deere S7 Series Combines
Setting up Header (John Deere S7 Series)
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
Summary of Contents for FlexDraper FD1 Series
