MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 235 / 354

214685
223
Revision A
7.1.9 Gleaner R65/R66/R75/R76 and S Series Combines
Checking Voltage Range from the Combine Cab (Gleaner R65/R66/R75/R76 and Pre-2016
S Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
1. Position the header 150 mm (6 in.) above the ground, and unlock the float.
Figure 7.157: Float Lock
2. Check that float lock linkage is on down stops
(washer [A] cannot be moved) at both locations.
NOTE:
If the header is not on down stops during the next two
steps, the voltage may go out of range during operation
causing a malfunction of the AHHC system.
Figure 7.158: Float Indicator Box
3. Ensure pointer (A) on the float indicator box is on 0. If
necessary, adjust the cable take-up bracket (B) until
pointer is on 0.
SETTING UP AUTO HEADER HEIGHT CONTROL