MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 106 / 354

214685
94
Revision A
Figure 5.75: Header on Combine
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
5. Start the engine and slowly drive the combine up to the
float module until feeder house saddle (A) is directly
under float module top cross member (B).
6. Raise the feeder house slightly to lift the header,
ensuring the feeder saddle is properly engaged in the
float module frame.
7. Stop the engine and remove the key from the ignition.
Figure 5.76: Feeder House Locks
8. Lift lever (A) on the float module on the left side of the
feeder house, and push handle (B) on the combine to
engage locks (C) on both sides of the feeder house.
9. Push down on lever (A) so the slot in the lever engages
the handle and locks the handle in place.
10. If the lock does not fully engage pin (D) on the float
module when lever (A) and handle (B) are engaged,
loosen bolts (E) and adjust lock (C). Retighten bolts.
Figure 5.77: Float Module Receptacle
11. Open the cover on receptacle (A) located on the left
side of the float module.
12. Push in lock button (B) and pull the handle (C) to the full
open position.
13. Clean the receptacle mating surfaces.
ATTACHING HEADER TO COMBINE