214685
12
Revision A
Figure 2.12: View from Below Header
8.
Remove four bolts (A) and remove shipping stands (B)
from the bottom of the float module.
Figure 2.13: Coupler Cover
9.
Remove two bolts (A) securing the bottom of coupler
cover (B) to the float module.
IMPORTANT:
Do
NOT
remove bolts (C) because they hold
multicoupler components in place. Loosen bolts (C)
only enough so that coupler cover (B) can be removed,
and then make sure you retighten the bolts.
10. Loosen two bolts (C), slide coupler cover to the left until
cutouts are aligned with bolts, and then remove
coupler cover.
11. Tighten two bolts (C).
Figure 2.14: Shipping Stands at Outboard Legs
(Right Side Shown)
12. Remove the four bolts (A) from the shipping stands at
both outboard header legs. Remove stands.
Summary of Contents for FlexDraper FD1 Series
