214685
290
Revision A
Figure 7.305: John Deere S7 Display
–
Header
Calibration
11. Select START on calibration overview page.
12. Follow instructions that appear on combine display. As
you proceed through calibration process, display will
automatically update to show next step.
NOTE:
If an error code appears during calibration, sensor is out
of voltage range and will require adjustment. Refer to
Adjusting Voltage Limits: One-Sensor System, page
162
Figure 7.306: John Deere S7 Display
–
Header
Calibration
13. When calibration is complete, select SAVE to confirm
calibration.
7.1.15
New Holland Combines (CR/CX Series
—
Pre-2015 Model Year)
This section applies only to pre-2015 CR/CX models. For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and
10.90, refer to
7.1.16 New Holland Combines (CR Series
Model Year 2015 and Later), page 300
.
Checking Voltage Range from the Combine Cab (New Holland)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
7.1.16 New Holland Combines (CR
Model Year 2015 and Later), page 300
CAUTION
Check to be sure all bystanders have cleared the area.
1.
Position the header 150 mm (6 in.) above the ground, and unlock the float.
Summary of Contents for FlexDraper FD1 Series
