MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 312 / 354

214685
300
Revision A
Figure 7.323: New Holland Combine Controls
1. Engage the threshing mechanism and the feeder with
switches (A) and (B).
2. Set HEADER MEMORY rocker switch (D) in STUBBLE
HEIGHT/AUTOFLOAT mode position (A) or (B).
3. Lower the header to the desired cutting height using the
HEADER HEIGHT and HEADER LATERAL FLOAT
momentary switch (C).
4. Lightly press AUTOMATIC HEADER HEIGHT
CONTROL button (E) for a minimum of 2 seconds to
store the height position. A beep will confirm the setting.
NOTE:
It is possible to store two different header height values
by using HEADER MEMORY rocker switch (D) in
STUBBLE HEIGHT/AUTOFLOAT mode
position (A) or (B).
5. To change one of the memorized header height set
points while the combine is in use, use the HEADER
HEIGHT AND HEADER LATERAL FLOAT rocker
switch (C) (slow up/down) to raise or lower header to
the desired value. Lightly press the AUTOMATIC
HEADER HEIGHT CONTROL button (E) for a minimum
of 2 seconds to store the new height position. A beep
will confirm setting.
NOTE:
Fully pressing AUTOMATIC HEADER HEIGHT
CONTROL button (E), will disengage float mode.
NOTE:
It is not necessary to press rocker switch (D) again after
changing header height set point.
7.1.16 New Holland Combines (CR Series
—
Model Year 2015 and Later)
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015
New Holland combine models, refer to
7.1.15 New Holland Combines (CR/CX Series
—
Pre-2015 Model Year),
page 290 .
Checking Voltage Range from the Combine Cab (New Holland CR Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator
’
s manual for updates.
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015
New Holland combine models, refer to
7.1.15 New Holland Combines (CR/CX Series
—
Pre-2015 Model Year),
page 290 .
CAUTION
Check to be sure all bystanders have cleared the area.
SETTING UP AUTO HEADER HEIGHT CONTROL