![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032017.webp)
214685
5
Revision A
Chapter 2:
Unloading
Perform all procedures in this chapter in the order they are listed.
2.1
Unloading Header and Float Module from Trailer
The following procedure assumes that two headers were shipped on the trailer.
CAUTION
To avoid injury to bystanders from being struck by machinery, do not allow people to stand in
unloading area.
CAUTION
Equipment used for unloading must meet or exceed the requirements specified below. Using inadequate
equipment may result in chain breakage, vehicle tipping, or machine damage.
IMPORTANT:
Forklifts are normally rated with the load centered 610 mm (24 in.) from the back end of forks. To obtain forklift
capacity for a load centered at 1220 mm (48 in.), check with your forklift distributor.
Figure 2.1: Minimum Lifting Capacity
A - Load Center of Gravity
B - Load Center 1220 mm (48 in.) from Back of Forks
C - Minimum Fork Length 1981 mm (78 in.)
Table 2.1 Lifting Vehicle Requirements
Minimum Lifting
Capacity
4082 kg (9000 lb.)
load center (A) at 1220 mm (48 in.)
(B) from back of forks
Minimum Fork
Length (C)
1981 mm (78 in.)
To unload headers and float modules from a trailer, follow these steps:
1.
Move trailer into position and block trailer wheels.
2.
Lower trailer storage stands.
Summary of Contents for FlexDraper FD1 Series
