214685
66
Revision A
Figure 5.12: AGCO Group Feeder House
5.
Use the lock handle (B) to engage lugs (A) with the float
module.
CAUTION
Never start or move the machine until you are sure all bystanders have cleared the area.
6.
Start the engine and lower the header.
7.
Stop the engine and remove the key from the ignition.
NOTE:
The FM100 Float Module is equipped with a multicoupler that connects to the combine. If your combine is
equipped with individual connectors, a multicoupler kit (single-point connector) must be installed. Refer to
Table
for a list of kits and installation instructions that are available through your combine Dealer.
Table 5.2 Multicoupler Kits
Combine
Kit Number
Challenger
71530662
Gleaner R/S Series
71414706
Massey Ferguson
71411594
Figure 5.13: Float Module Multicoupler
8.
Raise the handle (A) to release the multicoupler (B)
from the float module.
Summary of Contents for FlexDraper FD1 Series
