MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 300 / 354

214685
288
Revision A
Calibrating Header (John Deere S7 Series)
Feeder house calibration must be done before header calibration. If feeder house has not yet been calibrated, refer
to
Calibrating Feeder House (John Deere S7 Series), page 285 .
For best performance of auto header height control (AHHC), perform these procedures with header at steepest
angle. When setup and calibration are complete, adjust center-link back to desired header angle. For instructions,
refer to Header Angle in the header operator
’
s manual.
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
1. Ensure center-link is set to D .
2. Rest header on down stops and unlock float.
3. Place wings in locked position.
Figure 7.300: John Deere S7 Display
–
Harvesting Page
4. On the HARVESTING page, select the MENU icon (A)
in the bottom right corner of screen. The MENU opens.
Figure 7.301: John Deere S7 Display
–
Machine
Settings
5. Select MACHINE SETTINGS tab (A).
6. Select CALIBRATIONS & PROCEDURES icon (B). The
CALIBRATIONS & PROCEDURES page displays.
SETTING UP AUTO HEADER HEIGHT CONTROL