![background image](http://html2.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_unloading-and-assembly-instructions_3353032175.webp)
214685
163
Revision A
Adjusting Voltage Limits: Two-Sensor System
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Extend guard angle fully; the header angle indicator should be at
D
.
2.
Position header 150
–
254 mm (6
–
10 in.) above the ground; the float indicator should be at
0
.
Figure 7.15: Optional Two-Sensor Kit
–
Left Sensor
3.
Follow these steps to adjust left sensor voltage:
a.
Loosen sensor-mounting nuts (A).
b.
Rotate sensor (B) counterclockwise to lower the
voltage. Rotate sensor clockwise to raise the
voltage.
c.
Check that the left sensor is at the correct high
voltage limit.
d.
Tighten sensor-mounting nuts (A).
Summary of Contents for FlexDraper FD1 Series
