214685
320
Revision A
9.1.1
Adjusting Knife
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
Figure 9.6: Knifehead and Pitman Arm
1.
Stop engine and remove the key.
2.
Check guards for signs of heating during run-up due to
insufficient clearance between guard and knife.
3.
If heating is evident, check gap between knifehead (A)
and pitman arm (B). A business card should slide easily
through the gap. If not, adjust gap by loosening bolt and
tapping knifehead (A) with a hammer. Retighten bolt.
Figure 9.7: Straightening Tool
–
Upward
Adjustment
4.
Adjust guard alignment as necessary using guard
straightening tool (MD #140135). Adjust guard tips
upwards by positioning tool as shown, and pulling up.
Figure 9.8: Straightening Tool
–
Downward
Adjustment
5.
Adjust guard tips downward by positioning tool as
shown, and pushing down.
Summary of Contents for FlexDraper FD1 Series
