MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 87 / 354

214685
75
Revision A
5.3 John Deere Combines
The FD1 Series FlexDraper® Header is compatible with John Deere 60, 70, S, and T Series combines.
5.3.1 Installing Reel Fore-Aft / Header Tilt Switch: S and T Series Combines
The reel fore-aft/header tilt switch allows the combine Operator to select either reel FORE-AFT or HEADER
TILT mode.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under machine for any reason.
This procedure is applicable to John Deere S and T Series combines. For John Deere 60 or 70 Series combines,
refer to
5.3.2 Installing Reel Fore-Aft / Header Tilt Switch: 60 and 70 Series Combines, page 79 .
IMPORTANT:
To prevent damage to electronic components, disconnect the positive cable from the combine battery and turn the
battery disconnect switch to the OFF position before connecting the reel fore-aft/header tilt harness to the
combine
’
s auxiliary power connectors.
Prepare the combine cab for switch and harness installation as follows:
Figure 5.33: Storage Compartment and Cover
1. Open storage compartment on the console.
2. Remove the two screws (A) attaching compartment
cover (B) to console and remove cover.
Figure 5.34: Floor Mat at Forward Right Corner
and Knockout
3. Lift floor mat (A) at forward right corner to access
knockout (B).
4. Remove the knockout (B).
ATTACHING HEADER TO COMBINE