MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 71 / 354

214685
59
Revision A
4.3.3 Replacing Feed Deflectors on New Holland CR Combines
Figure 4.63: Feed Deflector
1. Remove the two bolts and nuts (B) securing the feed
deflector (A) to the float module frame, and remove the
feed deflector.
2. Position the replacement feed deflector (A), and secure
with bolts and nuts (B) (ensure the nuts are facing the
combine). Do
NOT tighten nuts.
Figure 4.64: Pan and Deflector Distance
3. Adjust deflector (A) so that distance (C) between pan
and deflector is 4
–
6 mm (5/32
–
1/4 in.).
4. Tighten nuts (B).
5. Repeat for opposite deflector.
6. Attach header onto the combine. Refer to 5 Attaching
Header to Combine, page 61 .
7. After attaching header to combine, extend center-link
fully, and check gap between deflector and pan.
Maintain the 4
–
6 mm (5/32
–
1/4 in.) gap.
SETTING UP FLOAT MODULE