214685
85
Revision A
Figure 5.56: Multicoupler
10. Slide latch (A) to lock the handle (B) in position and
secure with lynch pin (C).
11. If the float module is equipped with the reel
fore-aft/header tilt selector, connect harness (D) to
combine connector (E).
Figure 5.57: Driveline
12. Detach safety chain (C) from support bracket (B)
13. Pull collar (D) back to release driveline (A) from support
bracket. Remove the driveline from the support bracket.
Figure 5.58: Driveline
14. Pull back the collar (A) on the end of the driveline, and
push the driveline onto the combine output shaft (B)
until the collar locks.
Summary of Contents for FlexDraper FD1 Series
