MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 152 / 354

214685
140
Revision A
6.15 Checking Draper Seal
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before adjusting machine.
Figure 6.65: Draper Seal
1. Lower header to working position. Stop engine, and
remove key from ignition.
2. Check that clearance (A) between draper (B) and
cutterbar (C) is 0
–
3 mm (1/8 in.). Take measurements
at deck support locations. Refer to chart and illustration
on following page for approximate support locations.
Table 6.4 Deck Support Locations
Header
Approximate Location of Support from Drive Roller
Size A B C D E
9.1 m
(30 ft.) (G)
354 mm
(13-15/16 in.)
1773 mm
(69-13/16 in.)
3191 mm
(125-5/8 in.)
– –
10.7 m
(35 ft.) (H)
354 mm
(13-15/16 in.)
1550 mm
(61 in.)
2747 mm
(108-3/16 in.)
3949 mm
(155-7/16 in.)
–
12.2 m
(40 ft.) (H)
354 mm
(13-15/16 in.)
1809 mm
(71-1/8 in.)
3258 mm
(128-1/4 in.)
4710 mm
(185-7/16 in.)
–
13.7 m
(45 ft.) (J)
354 mm
(13-15/16 in.)
1864 mm
(73-3/8 in.)
3486 mm
(137-1/4 in.)
4483 mm
(176-1/2 in.)
5479 mm
(215-11/16 in.)
PERFORMING PREDELIVERY CHECKS