214685
215
Revision A
Figure 7.137: CLAAS Combine Display,
Console, and Control Handle
7.
Use control knob (A) to highlight the icon that
resembles a screwdriver (B).
8.
Engage the combine separator and feeder house.
9.
Press control knob (A) and a progress bar chart will
appear.
Figure 7.138: CLAAS Combine Display,
Console, and Control Handle
10. Fully raise the feeder house. The progress bar chart will
advance to 25% (A).
11. Fully lower the feeder house. The progress bar chart
will advance to 50%.
12. Fully raise the feeder house. The progress bar chart will
advance to 75%.
13. Fully lower the feeder house. The progress bar chart
will advance to 100%.
Figure 7.139: CLAAS Combine Display,
Console, and Control Handle
14. Ensure the progress bar chart displays 100% (A). The
calibration procedure is now complete.
NOTE:
If the voltage is not within the range of 0.5
–
4.5 V at any
time throughout the calibration process, the monitor will
indicate learning procedure not concluded.
NOTE:
If float was set heavier to complete ground calibration
procedure, adjust to recommended operating float after
the calibration is complete.
Summary of Contents for FlexDraper FD1 Series
