MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 135 / 354

214685
123
Revision A
Figure 6.30: Center-Link
3. Adjust center-link (A) so that indicator (B) is between B
and C on gauge (C).
4. Park combine on level ground and raise header until
cutterbar is 152
–
254 mm (6
–
10 in.) off the ground.
5. Shut down the engine, and remove the key from the
ignition.
6. If installed, move stabilizer/transport wheels so that
they are supported by header. Refer to instructions
provided with the stabilizer/transport system.
Figure 6.31: Linkage Cover
7. Remove linkage cover (A) by removing bolt (B) and
rotating cover upward until inboard end can be lifted off.
Figure 6.32: Linkage Cover
NOTE:
Refer to the decal (A) inside each linkage cover.
PERFORMING PREDELIVERY CHECKS