MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 313 / 354

214685
301
Revision A
1. Position the header 150 mm (6 in.) above the ground, and unlock the float.
Figure 7.324: Float Lock
2. Check that float lock linkage is on down stops
(washer [A] cannot be moved) at both locations.
NOTE:
If the header is not on down stops during the next two
steps, the voltage may go out of range during operation
causing a malfunction of the auto header height control
(AHHC) system.
Figure 7.325: Float Indicator Box
3. Adjust cable take-up bracket (B) (if necessary) until
pointer (A) on the float indicator is on
0 .
4. Ensure header float is unlocked.
SETTING UP AUTO HEADER HEIGHT CONTROL