MacDon FlexDraper FD1 Series, Unloading And Assembly Instructions

Page: 50 / 354

214685
38
Revision A
Figure 4.15: Medium Configuration (Left Side)
8. Install two bolt-on flightings (A) on the left side of the
auger as shown, and secure each flighting with six
carriage head bolts and nuts retained from Step
3, page
37 at locations (B).
IMPORTANT:
Flighting bolt heads must be installed on inside of auger
to prevent damage to internal components.
NOTE:
Flightings are NOT included in this kit. Order flighting
kits MD #287031 separately.
9. Torque all nuts and bolts to 47 Nm (35 lbf·ft) to eliminate
deflection on flighting, then torque them to 58
–
64 Nm
(43
–
47 lbf·ft).
Figure 4.16: Medium Configuration Flighting
Plug (Right Side)
10. Use the access hole (A) to position the flighting slot
plug (B) from inside the feed auger (as shown) and
secure with a 20 mm long M6 hex head bolt (C) and tee
nut. Use flighting and hardware retained from Step
5,
page 37 . Repeat for the remaining locations used to
mount the flighting in Step 3, page 37 and Step 4, page
37 .
11. Install additional auger fingers. A total of 22 auger
fingers is recommended for this configuration. Refer to
4.2.10 Installing Feed Auger Fingers, page 54 .
4.2.2 Converting from Wide Configuration to Medium Configuration
One kit of MD #287031 2 is required to convert to this configuration.
Figure 4.17: Auger Configurations (Rear View)
1 - Wide Configuration 2 - Medium Configuration
Wide and Medium auger configurations are shown at right.
When converting from Wide configuration to Medium
configuration, you will need to install new flightings (A).
SETTING UP FLOAT MODULE
2. MD #287031 contains wear-resistant flightings, and is available only through MacDon Parts.